
groov Box User’s Guide 73
73
C: A: AppTitleAppendix D
D: Installing an Approved USB
WiFi Adapter
If you want to use the groov Box on a wireless network, you must purchase and install one of the
following USB WiFi adapters Opto 22 has tested and approved for use with GROOV-AR1.
Unapproved WiFi adapters should not be used.
• Netis WF2119S
• Netis WF2116
• Rosewill RNX-N150UBE
• Patriot Memory PCUSBW1150
Install the WiFi adapter and restart the groov Box as follows:
1. If the groov Box is on, press the On/Off button to turn it off.
CAUTION: If you press the button for longer than eight seconds, the groov Box will be restored to
default settings. Your project and all passwords will be erased.
2. Insert the WiFi adapter into the USB connector on the top of the device.
3. Firmly press the On/Off button. The Power LED will turn on. Wait until the SYS LED has stopped
blinking and is solid green.
4. Open groov Admin as described on page 20.
5. Configure wireless communications as described on page 32.
USB connector for
WiFi adapter
Top
Comentarios a estos manuales