Rosewill WIRELESS N ADAPTER RNX-N150UBE Guía de usuario descargar pdf (Pagina 41)

CONFIGURING NETWORK CONNECTIONS

groov Box User’s Guide

7. In the Boot Time Interface Parameters, select From DHCP.

Normally, the DHCP server assigns an IP address. However, if no DHCP server is present, a static

IP address may be used.

8. Click Save.

Wait till you see the following message.

Congratulations. You’re connected!

9. If ETH0 and WLAN are on the same subnet, disconnect the cable from ETH0.

NOTE: You need to disable ETH0 because groov Box will continue to communicate over ETH0 as long

as it is connected on the same subnet and enabled. However, if you are using a control network and

enterprise network, and ETH0 is on a different subnet, you can leave it connected.

10. Disable ETH0 as follows:

a. Click ETH0.

b. Select Disabled, then click Save.

c. Click the Back button, and notice that ETH0 is disabled (Down) and WLAN0 is now enabled

(Up).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 82 83

Sin comentarios

Rosewill WIRELESS N ADAPTER RNX-N150UBE Guía de usuario Pagina 41