Rosewill WIRELESS N ADAPTER RNX-N150UBE Guía de usuario descargar pdf (Pagina 21)

STEP 6. TURN ON THE GROOV BOX

groov Box User’s Guide

b. Connect the COM wire from the power supply (normally black) to the – (negative) terminal on

the power connector.

c. Plug the power supply into a standard 120 or 240 VAC outlet.

Step 6. Turn on the groov Box

Firmly press the On/Off button until the SYS LED lights up (in about one second), then release. Take

a look at the LNK ACT light for ETH0; if the cable is properly connected, the LNK ACT light should be

on or blinking.

NOTE: Always wait until the SYS LED has stopped blinking before you try to log into groov. Otherwise,

you may not be able to use the hostname to log in. If this happens, see page page 65.

CAUTION: If you press the button for longer than eight seconds, the groov Box will be reset to default

settings. Your project and all passwords will be erased.

Step 7. Activate the groov Box and Get the License File

a. Open a web browser. Go to activate.groov.com.

b. Log in using your email address and your My.Opto22 password.

You may have set up your free My.Opto22 account when you purchased your groov Box. If you

don’t have a My.Opto22 account, enter your email address and other information, and the

account will be created.

On/Off button

and Power LED

ETH0 LNK ACT light

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 82 83

Sin comentarios

Rosewill WIRELESS N ADAPTER RNX-N150UBE Guía de usuario Pagina 21