
T600N - Wireless Dual Band Gigabit Router
86
CONFIGURATION GUIDE
Routing: Typically static routing does not need to be setup because the T600N has
adequate routing information after it has been configured for Internet access. Static
routing is only necessary if the router is connected to network under a different
subnets.
• NAT Disabled:
• Enable Static Routing: Click Enable Static Routing to activate the feature.
• Destination LAN IP: Enter the LAN IP address of the destination
device.
• Subnet Mask: Enter the Subnet Mask of the destination device.
• Default Gateway: Enter the default gateway IP address for the
destination device.
• Hops: Enter the maximum number of hops within the static
routing that a packet is allowed to travel.
• Interface: You can select LAN or WAN here.
Click Apply to save the settings or Cancel to discard the changes.
Advanced – Routing
Note: To enable routing, you will first need to disable NAT.
Comentarios a estos manuales